INSTRUCTIONS: 1. Warm up the engine after changing engine oil and filter. 2. Turn engine off. 3. Shake container to ensure particles are well dispersed in solution. 4. Inject the treatment into engine through oil filler. 5. Replace and tighten oil filler cap. 6. Start engine and let idle for 10-15 minutes, then drive vehicle or operate engine normally.
BENEFITS: In general, engine abrasion is caused by abnormal lubrication due to starting an engine that has not been used for a long period of time or by driving without warming the engine up or under other serious conditions. CealDoctor ™ heals worn out parts by forming a lubricant membrane on the inner wall of the engine. Tight metallic cohesion is conducted by heat and pressure. CealDoctor™ acts like a ball bearing between friction parts, and prevents abrasion and reduces friction. CealDoctor™ Increases Resistance and Prevents Abrasion and Improves Engine Performance by Increasing The Cooling Effect.
INHALATION: At ambient / normal handling temperatures, inhalation of vapors is normally not a problem. If overexposed to oil mist, remove yourself from further exposure. Administer artificial respiration if breathing is irregular or has stopped. Get prompt medical attention. SKIN CONTACT: Wash thoroughly with plenty of water, using soap if available. Remove contaminated clothing. If irritation persists, get medical attention. EYE CONTACT: Rinse immediately with plenty of water until irritation subsides. If irritation persists, obtain medical advice. INGESTION: If swallowed, DO NOT induce vomiting: keep at rest and call a physician. EXTINGUISHING MEDIA: Foam, dry chemical powder, carbon dioxide. FIRE AND EXPLOSION HAZARDS: Combustible material, low hazard. The product can form flammable mixtures or can burn only on heating above the flash point. However, minor contamination by hydrocarbons of higher volatility may increase the hazard. SPECIAL FIRE-FIGHTING PROCEDURES: Water fog or spray, to cool fire-exposed surfaces (e.g. containers) and to protect personnel, should only be used by personnel trained in fire fighting. Cut off “fuel”; depending on circumstances, either allow the fire to burn out under controlled conditions or use foam or dry chemical powder to extinguish the fire. Respiratory and eye protection required for fire fighting personnel exposed to fumes or smoke. HAZARDOUS COMBUSTION PRODUCTS: Smoke and carbon monoxide may be formed in the event of incomplete combustion.
QUICK INJECTION PROCEDURE
1. Change engine oil and filter before injection of CealDoctor™ products 2. Start engine and leave on low idle 3. Gasoline Engines – 200 ml bottle for every 4 litres of motor oil 4. Diesel Engines – 200 ml bottle for every 6 litres of motor oil 5. Replace oil filler cap 6. Leave engine idling for 15 – 30 minutes to ensure proper coverage
IMPORTANT NOTICE: KEEP OUT OF REACH OF CHILDREN.AND ANIMALS
First Name: *
Last Name: *
E-mail address: *
Product:
Comment(s):
